KTV804 compatible LCD display general 9 inch for CNCmachine replace old RGB MDA EGA CGA industrial CRT monitor
This productis used to replace a variety of CNC machine set old RGB, MDA, EGA, CGAindustrial CRT monitors, wide compatibility, good effect.
Size 8.4-inch LCD, commonly known as 9-inch display.
KTV804 RGB, MDA, EGA, CGA special industrialmonitors
1,supports the 15k to 48k line frequency signal,unrestricted field frequency input, automatic identification line fieldfrequency input.
2,supports digital RGB, RGB analog and color,monochrome, black and white, grayscale and other video formats.
3,Supports both interlaced and progressivescanning modes.
4,Support for vertical resolution from 160 linesto 600 lines, automatic identification.
5,Support any level of resolution, automaticidentification.
6,synchronizing signal separating support, thecomposite synchronization signal or the composite synchronizing signal on avideo signal, automatic identification.
7, the output signal of the standard 800 x 600VGA 60Hz field frequency or custom resolutions.
8, the input impedance of 75 ohms or 750 ohmsoffer two options, you can adapt weak signal equipment.
Model | KTV804 RGB EGA CGA MDA display | |
display size | 174*131mm 8.4" 4：3 | |
H&V scanning range | scan line signal:15Khz-48Khz positiveand negative automatic adaptation | |
Field scan signal:48hz-75hz positiveand negative automatic adaptation | |
Input signal | Signal type | MDA、CGA、EGA、VGA
RGB、RGsB、RGBS、RGBHV | |
|
Synchronous mode | HV line field separate,HV line fieldblending Cs,Green sync Sog | |
TTL digital level 2.4-5.0V or Low 0-0.8V | |
Analog level 0.7-2.5VP-P | |
Input impedance | 75-500 ohm high input impedance,automatically adapt to a variety of strong and weak signal source. | |
Scanning mode | Interlaced scan / progressive scan | |
The signal line | 9 pin or 15 pin | |
Display color | 262K, monochrome, black and white | |
contrast ratio | 450:1 | |
Brightness | 400 cd/m2 | |
work environment | Temperature: -10-+65,humidity: 20%-95% | |
Installation size | Including installation of border240*150*50mm | |
power adapter | External AC100V/240V to DC12V power,power: 18W,
Optional DC 24V power supply | |
The interface of the display
1. VIDEO IN: used to connect the 15 pin Dsignal line or the 9 pin D signal line input.(choose one only)
2. DC 12V: display power input, used toconnect the power adapter.(can choose 24VDC)
15 pin connector
Your cart is empty
NEW YASKAWA AC SERVO DRIVER SGDH-04AE-OY SGDH04AEOY EXPEDITED SHIPPING
MITSUBISHI AC SERVO MOTOR HC-UF43K HCUF43KNEW ORIGINAL EXPEDITED SHIPPING
YASKAWA AC SERVO MOTOR SGMJV-01ADE6S SGMJV01ADE6S NEW EXPEDITED SHIPPING
